Toro 2226, Руководство оператора

Страница: 64 / 108

Filling the TJC Applicator
1. Stop the machine and shut off the engine.
2. Loosen the wing nuts securing the cover straps
to the machine (Box A of
Figure 72 ).
g218945
Figure 72
3. Rotate the cover and pull the cover straps off the
retaining bolts (Box B and C of
Figure 72 ).
4. Lift the cover assembly off and out of the empty
thread-joint-compound bucket (Box D of
Figure
72 ).
5. Replace the empty bucket with a new full bucket.
6. Place the plunger into the new bucket and lower
the cover assembly onto the bucket.
7. Slide the cover straps over the retaining bolts
and rotate the cover to seat the straps on the
bolts.
8. Tighten the wing nuts.
Moving a Disabled Machine
Whenever the machine is stopped and the engine
is not running, the hydrostatic brakes automatically
engage. Do not attempt to tow the machine if it cannot
move under its own power. If possible, repair the
machine at the site. If this is not possible, use a crane
and a spreader bar to lift the machine onto a trailer,
using the lift points shown in
Figure 73 .
g218947
Figure 73
Repeat lift points on other side
1. Spreader bar 2. Lift point
64