Figure 24
1.
Self-propel drive bar
Note:
The maximum self-propel drive speed is
fixed. To reduce the speed, increase the space
between the self-propel drive bar and the handle.
2. To disengage the self-propel drive, release the
self-propel drive bar.
Note:
The machine comes with freewheeling
clutches which make it easier to pull the machine
rearward. To disengage the clutches, you may need
to push the machine forward 1 inch (2.5 cm) or
more after you release the self-propel drive bar.
Adjusting the Cutting Height
Cutting heights are from 1 inch (25 mm) to 4-1/2
inches (114 mm) in 1/2-inch (13 mm) increments.
WARNING
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
•
Stop the engine and wait for all moving parts
to stop.
•
Do not put your fingers under the housing
when adjusting the cutting height.
Adjust the cutting height as desired (Figure 25). Set all
four wheels to the same height.
Figure 25
1.
Highest height-of-cut
position (levers forward)
2.
Lowest height-of-cut
position (levers rearward)
Note:
To raise the mower, move all 4 cutting height
levers forward; to lower the mower, move them
rearward.
Recycling the Clippings
Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass bag is on the machine, remove it (refer to
Removing the Grass Bag (page 16)) before recycling the
clippings. If the side discharge chute is on the machine,
remove it and lock the side discharge door (refer to
Removing the Side Discharge Chute (page 17)) before
recycling the clippings.
Important:
A safety switch prevents the machine
from starting unless the recycle plug is securely
installed (Figure 26).
Install the recycle plug as illustrated in Figure 26.
15
