
Form No. 3358-309 Rev A
Rear Bag Kit
For PT21 Lawn Mowers
Model No. 22159
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
1
Grass bag
1
Install the grass bag.
2
Bagging blade
1
Install the bagging blade.
The grass bag is fully assembled and ready to use.
Step
1
Installing the Grass Bag
Parts needed for this step:
1
Grass bag
Procedure
Use the grass bag when you want to collect grass
and leaf clippings from the lawn.
If the side discharge chute is on the mower,
remove it and lock the side discharge door before
bagging the clippings.
The blade is sharp; contacting the blade can
result in serious personal injury.
Stop the engine and wait for all moving parts
to stop before leaving the operating position.
1. Raise and hold up the rear door (Figure 1).
Figure 1
2. Remove the rear discharge plug.
3. Install the bag onto the door rod (see inset in
Figure 1).
4. Lower the rear door.
5. To remove the bag, reverse the steps above.
© 2007—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved