6
537
1
2
3
4
5
6
7
Figure 3
1.
Self-tapping screws
2.
Locknut
3.
Gas tank retainer
4.
Plastic clips
5.
Gas tank
6.
Gas tank bracket
7.
Tank base
4. Hook gas tank retainer onto rear of gas tank and slide
end of retainer into hole in tank bracket. Secure
retainer to tank bracket with locknut (Fig. 3). Do not
overtighten locknut.
5. Remove red cap from end of fuel line and from end of
elbow fitting on gas tank. Slide end of fuel line onto
elbow fitting (Fig. 4). Secure fuel line in place with
fuel line clamp.
2
1
3
538
Figure 4
1.
Fuel line clamp
2.
Fuel line
3.
Elbow fitting
Air Cleaner Cover
1. Insert bottom tabs of air cleaner cover into slots.
Rotate cover upwards and snap into place (Fig. 5).
1757
3
2
1
4
Figure 5
1.
Spark plug wire
2.
Primer
3.
cover
4.
Foam element
Discharge Tunnel Plug
1. Open the discharge door by pulling forward on the
handle and moving it rearwards (Fig. 6). Hold the
discharge door handle to prevent the spring-loaded
door from closing while inserting the plug.
2. Since the plug is slightly wider than the discharge
tunnel opening, rotate the plug clockwise slightly
while inserting it (Fig. 6). Make sure the arrow on the
plug decal is pointing upwards.
m–1914
2
1
Figure 6
1.
Discharge door handle
2.
Plug rotated clockwise
