Toro 21180, Руководство оператора

Страница: 11 / 16

blade bolt. Operating the mower without the blade
adapter will damage the mower.
Sharpening the Blade
Use a file to sharpen the top side of the blade and maintain
the original cutting angle.
Note:
The blade will remain balanced if you remove the
same amount of material from both cutting edges.
Important:
Check the balance of the blade by putting it
on a blade balancer. You can purchase an inexpensive
balancer at a hardware store. A balanced blade stays in a
horizontal position; an unbalanced blade settles to the
heavy side. If the blade is not balanced, file more metal
off the cutting edge on the heavy end of the blade.
Installing the Blade
Install a sharp, balanced blade and the blade bolt. The sail
part of the blade must point toward the top of the mower
housing to ensure correct installation. Tighten the blade bolt
to 20 N-m.
Servicing the On/Off and Blade
Brake System
The motor and blade are designed to stop within 3 seconds
after you release the control bar. Ensure that the control bar
functions properly each time before you operate the mower.
If the blade does not stop within 3 seconds or there is a
grinding or scraping, metal-to-metal noise when you release
the control bar, contact an Authorized Toro Service Dealer.
This same recommendation applies if you observe heavy
vibrations when using the mower.
11