appearance. If the grass is too long, the mower may
plug and cause the engine to stall.
•
Mow only dry grass or leaves. Wet grass and leaves
tend to clump on the yard and can cause the mower
to plug or the engine to stall.
Wet grass or leaves can cause serious injury if
you slip and contact the blade. Mow only in dry
conditions.
•
Alternate the mowing direction. This helps disperse
the clippings over the lawn for even fertilization.
•
If the finished lawn appearance is unsatisfactory, try
one or more of the following:
– Replace the blade or have it sharpened.
– Walk at a slower pace while mowing.
– Raise the cutting height on your mower.
– Cut the grass more frequently.
– Overlap cutting swaths instead of cutting a full
swath with each pass.
– Set the cutting height on the front wheels one
notch lower than the rear wheels. For example,
set the front wheels at D (52 mm) and the rear
wheels at E (63 mm).
Cutting Leaves
•
After cutting the lawn, ensure that half of the lawn
shows through the cut leaf cover. You may need to
make more than one pass over the leaves.
•
If there are more than 13 cm of leaves on the lawn,
set the front cutting height one or two notches
higher than the rear cutting height.
•
Slow down your mowing speed if the mower does
not cut the leaves finely enough.
Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 5 hours
• Change the engine oil.
Before each use or daily
• Check the engine oil level.
• Ensure that the engine stops within 3 seconds after releasing the blade control bar.
Every 25 hours
• Check the spark plug.
• Lubricate the self-propel drive.
• Replace the blade or have it sharpened (more frequently if the edge dulls quickly).
Every 50 hours
• Change the engine oil.
Every 100 hours
• Clean the cooling system (refer to your engine owner’s manual).
• Replace the spark plug (refer to your engine owner’s manual).
• Clean the cooling system.
Before storage
• Empty the fuel tank before repairs as directed and before annual storage.
Yearly
• Replace the air filter (more frequently in dusty operating conditions).
• Check the spark plug (refer to your engine owner’s manual).
• Refer to your Engine Operator’s Manual for any additional yearly maintenance
procedures.
Important:
Refer to your
Engine Operator’s Manual
for additional maintenance procedures.
12
