Toro 20318, Руководство оператора

Страница: 11 / 16

Servicing the Air Cleaner
Service Interval: Every 25 hours/Yearly (whichever comes
first)—Check the air cleaner for dirty,
loose, or damaged parts, and clean or
replace them if necessary.
Every 100 hours/Yearly (whichever comes first)
1. Perform the pre-maintenance procedures; refer to
Preparing for Maintenance (page 10).
2. Unscrew and open the air-cleaner cover (Figure 15).
G020152
Figure 15
1. Screw 3. Air-cleaner element
2. Air-cleaner cover
3. Replace the air-cleaner element.
4. Install the air-cleaner cover.
Changing the Engine Oil
Service Interval: After the first 5 hours
Every 50 hours/Yearly (whichever comes first)
Run the engine a few minutes before changing the oil to warm
it. Warm oil flows better and carries more contaminants.
1. Perform the pre-maintenance procedures; refer to
Preparing for Maintenance (page 10).
2. Remove the dipstick (Figure 16).
Figure 16
3. Set an oil-drain pan beside the machine by the dipstick.
4. Tip the machine onto its side, with the dipstick down,
to drain the used oil out through the oil-fill tube
(Figure 17).
G020153
Figure 17
5. After draining the used oil, return the machine to the
normal operating position.
6. Remove the dipstick and pour about 3/4 of the
crankcase capacity of oil into the oil-fill tube.
Note:
Max. fill: 22 oz. (0.65 l), type: 10W-30 or SAE
30 detergent oil with an API service classification of
SJ or higher.
7. Wipe off the dipstick end with a clean cloth.
8. Insert the dipstick into the oil-fill tube, but do not
screw it in.
9. Remove the dipstick and read the oil level on the
dipstick (Figure 16).
•
If the oil level is too low, add a small amount of
oil slowly to the oil-fill tube, and then repeat steps
7 through 9 until the oil level on the dipstick is
correct.
•
If the oil level is too high, drain the excess
oil until the oil level on the dipstick is
correct. To drain the excess oil, refer to
Changing the Engine Oil (page 11).
Important:
If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
10. Install the dipstick securely.
11. Recycle the used oil properly.
11