Toro 14AQ81RP848, Руководство оператора

Страница: 10 / 68

10
SECTION 4: TRACTOR SET-UP
In the event your tractor was crated with the steering
wheel removed for shipping reasons, use the following
instructions to properly assemble the parts.
Attaching The Steering Wheel
In the event your tractor was crated with the steering
wheel and the seat removed for shipping reasons, use
the following instructions to properly assemble the
parts.
Tools Required
(1) 1/2" socket wrench
1. The hardware for attaching the steering wheel has
been packed within the steering wheel, beneath
steering wheel cap. Carefully pry off the steering
wheel cap and remove the hardware.
2. With the wheels of the tractor pointing straight
forward,
place the steering wheel over the steering
shaft.
3. Place the washer (with the cupped side down) over
the steering shaft and secure with the hex bolt. See
Figure 1.
Figure 1
4. Place the steering wheel cap over the center of the
steering wheel and push downward until it “clicks”
into place.
Connecting the Battery Cables
CAUTION:
When attaching battery cables, always
connect the POSITIVE (Red) wire to its terminal first,
followed by the NEGATIVE (Black) wire.
For shipping reasons, both battery cables on your
equipment may have been left disconnected from the
terminals at the factory. To connect the battery cables,
proceed as follows:
NOTE:
The positive battery terminal is marked Pos.
(+). The negative battery terminal is marked Neg. (–).
1. Remove the plastic cover, if present, from the
positive battery terminal and attach the red cable to
the positive battery terminal (+) with the bolt and
hex nut. See Figure 2.
2. Remove the plastic cover, if present, from the
negative battery terminal and attach the black cable
to the negative battery terminal (–) with the bolt and
hex nut. See Figure 2.
3. Position the red rubber boot over the positive
battery terminal to help protect it from corrosion.
Figure 2
NOTE:
If the battery is put into service after the date
shown on top/side of battery, charge the battery as
instructed
on page 24 of this manual prior to operating
the tractor.
Cap
Washer
Hex Bolt
Steering Shaft