20
SECTION 7: MAKING ADJUSTMENTS
WARNING:
Never attempt to make any
adjustments while the engine is running,
Seat Adjustment
WARNING:
Before operating this machine,
make sure the seat is engaged in the seat
stop. Stand behind the machine and pull back
on seat until fully engaged into stop.
To adjust the position of the seat, move the lever to the
left and slide the seat forward or rearward. Make sure
seat is locked into position before operating the tractor.
Figure 12
Leveling the Deck
NOTE:
Check the tractor’s tire pressure before
performing any deck leveling adjustments. Refer to
Tires
on page 27 for information regarding tire pressure.
Front To Rear
The front of the cutting deck is supported by a stabilizer
bar that can adjusted to level the deck from front to rear.
The front of the deck should be between 1/4-inch and
3/8-inch lower than the rear of the deck. Adjust if
necessary as follows:
•
With the tractor parked on a firm, level surface,
place the deck lift lever in the top notch (highest
position) and rotate the blade nearest the discharge
chute so that it is parallel with the tractor.
•
Measure the distance from the front of the blade tip
to the ground and the rear of the blade tip to the
ground.
•
The first measurement taken should be between
1/4" and 3/8" less than the second measurement.
•
Determine the approximate distance necessary for
proper adjustment and proceed, if necessary, to the
next step.
•
From the front of the tractor, loosen the outermost
hex lock nut on each end of the deck hanger rod.
See Figure 13.
•
Tighten the inner hex nuts against the front hanger
bracket to raise the front of the deck; loosen the
inner hex nuts to lower the front of the deck. See
Figure 13.
Figure 13
•
Retighten the two lock nuts against the inner hex
nuts when proper adjustment is achieved.
Seat Adj
us
tme
n
t Leve
r
Содержание 14AQ81RP748
Страница 34: ...34 ELECTRIC SCHEMATIC ...
