Toro 140-2050, Инструкция по установке

Страница: 2 / 4

2
Removing the Guards
Machines Equipped with MyRide ®
Only
No Parts Required
Procedure
Note:
Retain all removed parts for later installation.
1. Remove the bolts securing the guards on the
sides of the frame.
2. Remove the guards on both sides of the frame
(
Figure 1 ).
g308507
Figure 1
3
Installing the Weights
Parts needed for this procedure:
4 Bolt (3/8 x 1 inch)
6 Locknut (3/8 inch)
1 Left weight-mounting bracket
1 Right weight-mounting bracket
2 Washer
2 Bolt (5/8 x 2-3/4 inches)
8
Suitcase weight
Procedure
CAUTION
The bagger changes the weight distribution of
the machine. Operating the machine without
the front weights may cause an unstable
condition, which could result in a loss of
control.
Ensure the front weights are properly installed
before operating the machine with the bagger
attachment.
1. Install the weight-mounting brackets to the under
side of the frame using 2 bolts (3/8 x 1 inch),
and 2 locknuts (3/8 inch) as shown in
Figure 2 .
2. Install suitcase weights to the weight mounting
brackets using 2 bolts (5/8 x 2-3/4 inches), 2
washers, and 2 locknuts (3/8 inch) as follows:
•
If your machine has a 42-inch stamped deck,
install 8 suitcase weights.
•
If your machine has any other cutting deck,
install 6 suitcase weights (
Figure 3 ).
3. Once you have installed all the weights and
brackets, ensure that all the fasteners are tight.
Tighten as necessary.
Important:
Whenever you remove the
bagger attachment, remember to remove the
front weights to return the proper stability
to the machine.
2