Form No. 3416-805 Rev A
Battery Cable Kit
Groundsmaster
®
5900 or 5910 Rotary Mower
Model No. 137-5470
Installation Instructions
Installation
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical
or chemicals known to the State of
California to cause cancer, birth defects,
or reproductive harm.
Preparing the Machine
1.
Park the machine on a level surface.
2.
Lower all decks to the ground.
3.
Engage the parking brake.
4.
Shut off the engine and remove the key.
5.
Allow the machine to cool.
Accessing the Battery
Compartment
Note:
Retain all parts removed unless otherwise
directed.
1.
Disconnect the battery using the
battery-disconnect switch; refer to your
Operator’s Manual
.
2.
Remove 3 flange screws from each side of the
rear bumper as shown in (
).
Important:
Support the bumper so that it
will not fall before removing any fasteners.
3.
Loosen the remaining flange screws securing
the rear bumper to the frame and pivot the
bumper downward.
g199824
Figure 1
1.
Rear bumper
3.
Flange screw (loosen on
both sides)
2.
Flange screws (remove
from both sides)
4.
Loosen the knobs and remove both side panels
(
).
g199825
Figure 2
1.
Knobs
2.
Side panel
5.
Loosen the 4 flange screws on the bottom of the
rear shroud and remove the 2 flange screws on
each side (
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3416-805* A
