Toro 136-1199, Руководство по установке

Страница: 6 / 8

5
Installing the Wheels
No Parts Required
Procedure
1. Install the wheel onto the hub using the previously
removed lug nuts (
Figure 2 ).
2. Torque the lug nuts in a star pattern to 102 to 129 N∙m
(75 to 95 ft-lb).
6
Adjusting the Front Wheel
Toe-in
No Parts Required
Procedure
The toe-in should be 0 to 6 mm (0 to 1/4 inch).
•
Check the tire pressure to ensure that the front tires are
inflated to 82 kPa (12 psi).
•
Either, add weight to the driver's seat equal to the average
operator who will run the machine, or have an operator
sit on the seat. The weight or operator must remain on
the seat for the duration of the procedure.
•
On a level surface, roll the machine straight back 2 to 3
m (6 to 10 ft) and then straight forward to the original
starting position. This allows the suspension to settle into
the operating position.
•
Measure the toe-in with the wheels facing straight ahead.
1. Measure the distance between both of the front tires at
the axle height at both the front and rear of the front
tires (
Figure 12 ).
G009235
1
2
3
Figure 12
1. Tire center line—back 3. Axle center line
2. Tire center line—front
2. If the measurement does not fall within 0 to 6 mm (0
to 1/4 inch), loosen the jam nuts at the outer end of
the tie rods (
Figure 13 ).
Figure 13
1. Tie rod 2. Jam nut
3. Rotate both tie rods to move the front of the tire
inward or outward.
4. Tighten the tie rod jam nuts when the adjustment is
correct.
5. Ensure that there is full travel of the steering wheel in
both directions.
6