Toro 136-0372, Руководство по установке

Страница: 11 / 64

5
Removing the Boom-Section
Valves
No Parts Required
Removing the Boom-Section Hoses
1. At the outer-boom section, remove the hose clamp
that secures the supply hose for the boom section to
the barbed T-fitting (
Figure 14 ).
Note:
Retain the hose clamp for installation in
Installing the Supply Hoses to the Boom Sections
(page 39)
Figure 14
1. Outer boom section
4. Hose clamp
2. Supply hose (outer-boom
section) 5. R-clamp
3. Barbed T-fitting
2. Remove the hose from the T-fitting ( Figure 14 ).
3. Remove the free end of the hose from the R-clamp
(
Figure 14 ).
4. Repeat steps 1 through 3 for the supply hose at the
other outer-boom section.
5. Under the center-boom section, remove the hose
clamp that secures the supply hose for the boom
section to the barbed T-fitting (
Figure 15 ).
Note:
Retain the hose clamp for installation in
Installing the Supply Hoses to the Boom Sections
(page 39)
.
Figure 15
1. Center boom-section valve 4. Supply hose (center-boom
section)
2. Center-boom section 5. Hose clamp
3. Left side of the machine 6. Barbed T-fitting
11