Toro 132-4193, Руководство по установке

Страница: 16 / 16

Figure 41
1. Rear bracket 2. Front bracket
B. Adjust the pipe-return proximity sensor until the
light illuminates (
Figure 40 ).
C. Tighten the bolts and nuts on the sensor.
D. Torque the bolts to 791 to 971 N-cm (70 to 86
in-lb).
7
Installing the Caps and Decal
Parts needed for this procedure:
1 Valve cap
1 Monitor cap
1 Decal
Procedure
Install the decal as shown in Figure 42 .
Figure 42
1. Decal
Remove the manual override valve screw and install the valve
cap as shown in
Figure 43 .
Figure 43
1. Valve cap 2. Manual-override valve
Gently lift the monitor away from the console using a flat
head screwdriver in the gaps as shown in Box A of
Figure 44 .
Figure 44
1. Gaps between the monitor and console panel
Insert the monitor cap into the port on the back of the
monitor and install the monitor back onto the console (Box
B of
Figure 44 ).
Connect the positive terminal of the battery then connect
the negative terminal.
16