Toro 130-5615, Руководство по установке

Страница: 12 / 20

Installing the Windshield
Washer Fluid Kit
For MD-Series Models
Removing the Roof Panel
Roof-panel weight: 9.5 kg (21 lb)
1. Remove the 10 bolts (1/4 x 1 inch) and 10 sealing
washers (1/4 inch) that secure the roof panel to the
roof-support brackets of the cab (
Figure 33 ).
Note:
Retain the bolts and washers for installation of
the roof panel in Installing the Overhead-Console Plug
and the Roof Panel (page 18) .
Figure 33
1. Bolt (1/4 x 1 inch) 3. Roof-support bracket
2. Sealing washer (1/4 inch) 4. Roof panel
2. Lift the roof panel straight up and remove it from the
cab of the machine.
Note:
Be careful when you set the roof panel down to
avoid damaging the surface and edges of the panel.
3. Remove the plug from the overhead console ( Figure
34 ).
Figure 34
1. Overhead console 2. Plug
Installing the Washer-Fluid Tank
1. Assemble the washer-fluid tank to the tank-support
bracket with the 2 carriage bolts (5/16 x 3/4 inch) and
2 flanged locknuts (5/16 inch) as shown in
Figure 35 .
Figure 35
1. Carriage bolt (5/16 x 3/4
inch) 3. Hole (washer-fluid tank)
2. Hole—square (tank
support bracket for
MD-series models—216 x
95 mm (8-1/2 x 3-3/4) with
90° flange) 4. Flanged locknut (5/16
inch)
2. Torque the flanged locknuts to 1,987 to 2,542 N∙cm
(175 to 225 in-lb).
3. At the lower headlight support, remove the 2
flanged-head bolts (1/4 x 5/8 inch), inboard of the
left headlight, that secure the left fender liner to the
headlight support (
Figure 36 ).
Note:
Retain the 2 flanged-head bolts for installation
of the washer-fluid tank and tank-support bracket.
12