the seat and the ignition key is in the RUN
position.
C. While using the High/Low Range diagnostic
screen on the InfoCenter, move the position
switch bracket just until the
front
Deck Down
input reads OFF. Refer to the Groundsmaster
5900 Service Manual for information on
InfoCenter operation.
This is the point in the raise sequence of the deck
where the deck position switch will shut off the
deck motor.
D. Tighten the switch bracket mounting fasteners.
Gap between sensing plate and switch target
should be maintained at 0.100 inches (+/- 0.030
inches).
Note:
The use of safety glasses is recommended
during the next step.
6. Operating each deck individually, verify the correct
operation of the switch by raising the deck with
the PTO engaged and observing that the blade
disengages before the outer blade tip of the deck
exceeds 39 cm.
5
Install Belt Cover Hardware
Parts needed for this procedure:
11
Thrust washer
11
Push nut (5/16 inch)
Procedure
1. Remove the bolt securing the belt cover to the deck
and remove the belt covers.
2. Install the existing bolt into the dedicated hole in the
belt cover. Install the thrust washer and push nut
from underneath to the existing bolt to retain it to
the belt cover as shown in Figure 8.
g01 1942
1
2
3
Figure 8
1.
Bolt (existing)
3.
Push nut (5/16 inch)
2.
Thrust washer
3. Install the belt cover to the deck. Use the retained
bolt to secure it to the deck.
4. Repeat for all the belt cover hardware.
6
Install the Decals
Parts needed for this procedure:
1
CE Compliance Decal
1
CE Warning Decal
1
Production Year Decal (included in traction unit loose
parts)
Procedure
1. Thoroughly clean the area where you will install the
decal (Figure 9).
4