1
All Rights Reserved
Printed in the USA
2003 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Light Kit
TimeCutter
Z Riding Mower
Part No. 106–2245
Form No. 3329–506
Installation Instructions
Note: This kit is for the TimeCutter Z Model 74350 only.
Loose Parts
Note: Use the chart below to identify parts used for assembly.
Description
Qty.
Use
Light assembly
1
Installing the light assembly
Wire harness
1
Installing the wire harness
Fuse
1
Installing the fuse
Drilling Holes for the Wire
Harness
There are two holes to drill for installing the wire harness.
One is located in the front and the other on the right side of
the frame.
1. In the front of the machine, measure 7–1/2 inches
(19 cm) over from the right adjusting nut and up 1–1/4
inches up from the mower frame (Fig. 1).
Note: The hole will be centered between the two adjusting
nuts.
2. Mark the location and drill a 1/4 inch dia. hole in the
front of the machine (Fig. 1).
3. Remove any burrs from the drilled hole on both sides of
the frame (Fig. 1).
m–6649
1
2
4
3
Figure 1
1.
1/4 inch hole to drill
2.
7–1/2 inches (19 cm)
3.
1–1/4 inches (32 mm)
4.
Right adjusting nut
4. Locate the hole on the right side of the machine by
measuring 3 inches (76 mm) over and 1–1/2 inches
(38 mm) up as shown in Figure 3.
5. Mark the location and drill a 1/4 inch dia. hole in the
side of the machine (Fig. 1).
6. Remove any burrs from the drilled hole on both sides of
the frame (Fig. ).
m–6660
2
3
1
4
Figure 2
1.
1/4 inch hole to drill
2.
3 inches (76 mm)
3.
1–1/4 inches (32 mm)
4.
Right side of the machine
Installing the Light Assembly
1. Remove the two bolts, washers, and locknuts that are on
the front of the machine and farthest to the outside
(Fig. 3).
