Toro 105-3848, Инструкция по установке, Страница: 2 / 4

2
2. Install the light switch into the control panel, securing
it with 2 nuts and a lockwasher (Fig. 4).
1
2
Figure 4
1. Light switch 2. Control panel
3. Under the control panel, locate a blue wire with a clear
protective covering over the terminal that is not
connected to anything and remove the protective
covering.
4. Connect the blue wire to one of the two leads on the
light switch.
Installing the Lights
1. Mark and drill 2 holes (11/32 in. dia.) through both
walls of the mow pedal guard at the locations
indicated in Figure 5.
m-5811
3
2
1
4
Figure 5
1. 3-1/2 in. (8.9 cm)
2. 10 in. (25.4 cm)
3. 1 in. (2.5 cm)
4. Drill holes (11/32 in. dia.)
2. Route the wire harness through the tubular light
bracket so that the connectors on the harness for the
lights are on either end of the bracket (Fig. 6).
m–5810
2
3
3
1
Figure 6
1. Tubular light bracket
2. Wire harness
3. Connectors
3. Install the light bracket to the front of the mow pedal
guard (Fig. 7), using 2 bolts (5/16 x 2-1/2 in.) and nuts
(5/16 in.).
1
2
3
4
4
Figure 7
1. Tubular light bracket
2. Mow pedal guard
3. Bolts, 5/16 x 2-1/2 in.
4. Light assemblies
4. Loosely mount a light to each end of the tubular
bracket with a lockwasher and nut (Fig. 7).