Toro 100 Series Z Master, Руководство оператора

Страница: 6 / 28

6
Before Installation
Checking the Mower for
Existing Holes
Check the mower for existing holes. Use any existing holes
in the mower that align with any of the parts to be installed
in their correct positions.
1
Step
Parts needed for this step:
•
1 Template
•
1 Bolt, #6 x 1/2 inch
Checking for Holes in the
Clutch
Look under the engine to view the clutch. Check to see if
there are existing holes in the clutch as shown in Figure 2.
•
If there are no existing holes, proceed to Drilling Holes
in the Clutch below.
•
If there are existing holes in the clutch, proceed to
Installing the Clutch and Drive Pulley Assembly on
page 7.
1
2
2
2
Figure 2
1. Clutch 2. Holes in clutch
Drilling Holes in the Clutch
Use the metal template, included with the bagger, to locate
the clutch holes.
1. Remove the clutch strap for the clutch (Fig. 3).
2. Unplug the clutch connector (Fig. 3).
1
2
3
4
m–4119
Figure 3
1. Clutch strap
2. Bolt
3. Clutch connector
4. Clutch
3. Remove the existing deck belt from the clutch.
4. Remove the existing clutch from the machine (Fig. 4).
Discard the bolt that was installed in the clutch.
5. Remove the existing drive spacer from the clutch
(Fig. 4).
1
m–6024
5
3
4
2
Figure 4
1. Engine
2. Clutch
3. Curved washers
4. Clutch bolt—discard
5. Drive spacer
6. Position the template into the clutch pulley so the
outside diameter is flush with the inside of the clutch
flange (Fig. 5).