Toro 09960, Руководство оператора, Страница: 33 / 92

Setting the Hole Depth
1. Ensure that the coring head is raised; refer to
Raising the Coring Head (page 27) .
2. Rotate the ignition key to the R
UN
position.
g358601
Figure 50
3. Press the right InfoCenter button until the Setting
the Hole Depth screen displays (
Figure 50 and
Figure 51 ).
4. Press the center button to select the Set Depth
option.
Note:
The Set Depth screen displays.
g357973
Figure 51
5. Adjust the tine depth ( Figure 52 ) as follows:
•
Press the InfoCenter center button to
decrease hole depth.
•
Press the right button to increase hole depth.
g357976
Figure 52
6. Press the left InfoCenter button to save your
setting and exit the set depth screen.
7. Rotate the ignition key to the O
FF
position.
Setting the Hole Spacing
Note:
When you select a target hole spacing rate,
the machine controls the ground speed to maintain
the hole spacing distance.
1. Ensure that the coring head is raised; refer to
Raising the Coring Head (page 27) .
2. Rotate the ignition key to the R
UN
position.
g358601
Figure 53
3. Press the right InfoCenter button until the Setting
the Hole Spacing screen displays (
Figure 53
and Figure 54 ).
33