Toro 09749, Руководство оператора, Страница: 14 / 48

Workman Tow Hitch
1. On the side of the tow hitch, slide the jack onto the
jack tube (
Figure 10 ).
Figure 10
1. Jack stand 2. Jack-stand tube
2. Rotate the jack stand to align the holes and secure with
the lynch pin (
Figure 10 ).
4
Positioning the Storage Pins
Parts needed for this procedure:
2 Storage pin
Procedure
The storage pins ( Figure 11 ) are to be inserted into the front
or rear holes of the core processor.
Front Hole Position
When the storage pins are inserted into the front holes, the
core processor can safely be disconnected and removed from
the tow vehicle (
Figure 11 ).
Rear Hole Position
After the core processor is connected to the tow vehicle,
insert the storage pins into the rear holes (
Figure 11 ).
Important:
The core processor can only be operated
when the pins are in the rear position
Figure 11
1. Storage pin 3. Rear hole (core processor
connected to tow vehicle)
2. Front hole (core processor
disconnected from tow
vehicle)
5
Mounting the Core Processor
for One-Pass Operation
Parts needed for this procedure:
1
Hitch pin (included with the one-pass hitch)
1 Lynch pin (included with the one-pass hitch)
2 Hitch pin (included with the one-pass hitch)
2 Lynch pin (included with the one-pass hitch)
5
Cable tie
Procedure
Note:
The core processor must be equipped with the One
Pass Hitch Kit (Model 09753) before it can be mounted to
the aerator.
1. Make sure that the processor brush is set for correct
height of cut.
2. Using a tie down or rope, secure the tow-arm hitch
plate to the frame hitch pivot while raising the tow-arm
for installation (
Figure 12 ).
14