Toro 08839, Руководство оператора

Страница: 37 / 64

Adjusting the Lift Links
1. Align the lift link to the lift-arm bracket, and rotate
the rod end until the hole in the rod end aligns
with the hole in the lift-arm bracket.
g365644
Figure 54
1. Flange locknut 4. Rod end (lift link)
2. Carriage bolt 5. Lift-arm bracket
3. Jam nut
2. Assemble the rod end to the lift-arm bracket with
the carriage bolt and locknut.
3. Tighten the jam nuts securing the rod end to the
lift link to 91 to 113 N
⋅
m (67 to 83 ft-lbs).
4. Repeat steps 1 through 3 at the other side of
the machine.
5. Start the engine, raise the mid-mount
attachment, remove the wood blocks, and
remove the stop pin from the 38 mm (1.5 inch)
above-grade attachment-stop hole.
6. Fully lower the mid-mount attachment to the
ground.
g365616
Figure 55
7. Shut off the engine, remove the key, and wait for
all moving parts to stop.
Raising and Lowering the
Optional Rear Attachment
1. Move the machine to the job site, and engage
the parking brake.
2. Use the rear attachment-lift control ( Figure
56 ) to adjust the position of an optional rear
attachment as follows:
•
Move the rear attachment lift control forward
to lower the rear attachment.
•
Move the rear attachment lift control rearward
to raise the rear attachment.
g384238
g335517
Figure 56
1. Rear attachment lift control 3. Raise the attachment
2. Lower the attachment
37