Toro 08839, Руководство оператора

Страница: 10 / 64

2
Preparing the Machine
No Parts Required
Procedure
1. Remove the machine from the crate, park the
machine on a level surface or move the machine
to a machine lift.
2. Engage the parking brake.
3. Lower the mid-mount attachment.
4. Shut off the engine and remove the key.
5. Wait for all moving parts to stop and allow the
engine to cool.
6. Move the mid-mount attachment control forward
and backward to relieve hydraulic pressure
(
Figure 3 ).
g384033
Figure 3
3
Installing the Rear
Attachment Lift Frame
Parts needed for this procedure:
2 Short drawbar chain (17-1/2 inches)
1 Lift bracket
6 Carriage bolt (5/16 x 1 inch)
4 Washer (3/8 x 7/8 inch)
6 Flange locknut (5/16 inch)
1 Rear attachment lift frame assembly
2 Long rear-lift chain (25 inches)
2 Shackle
2 Clevis pin
2 Cotter pin
2 Flange-head bolt (3/8 x 1-3/4 inches)
2
Washer (2/5 inch)
3 Flange locknut (3/8 inch)
2 Chain sleeve
6 Flange-head bolt (1/2 x 3 inches)
6
Flange locknut (1/2 inch)
1 Capscrew (3/4 x 4-1/2 inches)
1 Locknut (3/4 inch)
1 Flange-head bolt (3/8 x 1-1/2 inches)
Assembling the Drawbar Chains
to the Machine
1. Raise the operator’s platform ( Figure 4 ).
Note:
The operator’s platform does not stay in
the upright position; restrain the platform or hold
it in place while completing this procedure.
10