Toro 07511AA, Руководство пользователя программного обеспечения

Страница: 10 / 16

Changing the
InfoCenter Display
Brightness/Contrast
You can access the brightness and contrast in the
attachment, auto high, auto low, and inchmode.
Select the far right button to select the icon
brightness/contrast icon.
1. Select the brightness/contrast icon from the
pop-up-menu bar.
2. Use the plus and minus icons to change the
brightness/contrast pop-up-menu bar (
Figure
20 ).
g251545
Figure 20
1. Decrease brightness 4. Increase contrast
2. Increase brightness 5. Previous screen
3. Decrease contrast
Setting Up Parameters
To access the parameters, rotate the operation-mode
selector to the
S position ( Figure 21 ).
g250713
Figure 21
Using the Machine Parameters
Machine parameters are parameters that control
functions of the machine and not a specific
attachment.
Maximum Auto High Ground Speed
This allows the supervisor to limit the machine ground
speed when the machine is in the High Automotive
mode. It is adjustable from 1.6 to 33.8 km/hr (1 to 21
mph) in 0.16 km/hr (0.1 mph) increments.
Maximum Auto Low Ground Speed
This allows the supervisor to limit the machine ground
speed when the machine is in the Low Automotive
mode. It is adjustable from 1.6 to 12.9 km/hr (1 to 8
mph) in 0.16 km/hr (0.1 mph) increments.
Inch Mode
Select enable or disable.
Using the Attachment Parameters
This machine is unique in that each attachment is set
up before use and stored in the machine computer.
The attachment parameters set the limits for each
attachment used with this machine.
Note:
Ensure that the parking brake is engaged
when the operator is out of the seat when using a
stationary attachment.
The following are characteristics of parameters.
•
The parameters are protected by PIN settings for
supervisor control when security is turned on.
•
The parameters are the options on different
screens and every attachment does not use all
parameters.
•
The parameter choices are dependent on
the selection of the location, power source,
engagement method, and rate control.
•
You can save 16 different active attachments in
the machine computer.
Use the instructions on the screen to guide you
through and select the different parameters.
Attachment Location
This is the location where an attachment is connected
to the machine. The following are the different options:
•
3-P
OINT
—the attachment is connected the 3-point
hitch
•
O
THER
—the attachment is any attachment not
connected to the 3-point hitch
Attachment Power Source
This is the power source the attachment uses. The
following are the different options:
•
N
O
P
OWER
—the attachment requires no PTO or
hydraulic power (i.e. the attachment uses the draw
bar or the loader joystick, if installed)
•
PTO—the attachment requires PTO power only
10