Toro 07390 Workman HDX-Auto, Руководство по обслуживанию, Страница: 57 / 280

Workman HDX Auto Page 4 − 13 Drive Train
6. Note routing of shift cable and location of cable ties
used to secure cable to vehicle. Remove shift cable from
vehicle.
7. If necessary, remove jam nut and clevis from ends of
shift cable.
Shift Cable Installation (Fig. 12)
1. If clevis was removed from ends of shift cable, install
clevis and secure with jam nut. Center jam nuts on
threaded area of shift cable during assembly.
2. Route shift cable in same location as noted during
cable removal.
3. Connect shift cable to transmission lever in seat base
console by inserting clevis pin (item 8) from the passen-
ger side, then install hair pin.
4. Secure shift cable to lever support using cable clamp
(item 6) and two (2) screws (item 7). Make sure that rib
in clamp and groove in cable align correctly.
5. With shift cable properly routed to transmission, se-
cure cable to shift lever and bracket on engine/transmis-
sion mount:
A. Install clevis pin and hair pin to secure shift cable
to shift lever on transmission.
B. Secure shift cable to shift cable mount bracket on
engine/transmission mount with cable jam nuts (item
6 in Fig. 14). Center jam nuts on threaded area of shift
cable during assembly.
6. Install cable ties in the original locations to secure
shift cables to vehicle.
7. Adjust shift cable to allow full range of motion be-
tween PARK and DRIVE at transmission lever on con-
sole (see Shift Cable Adjustment in the Adjustments
section of this chapter).
8. Install shift and control plates to seat base and then
secure knobs to control levers (Fig. 13).
1. Transmission lever
2. Shift plate
3. Speed range lever
4. Control plate
5. Hydraulic lever
Figure 13
1
5
4
2
3
1. Transmission
2. Shift
cable
3. Hairpin
4. Clevis
pin
5. Cable clevis
6. Jam nut (2)
7. Jam nut (2)
Figure 14
2
3
6
1
5
4
7
7
Safety
Product Records
Drive T
rain