Toro 07390 Workman HDX-Auto, Руководство по обслуживанию, Страница: 228 / 280

Workman HDX Auto Page 7 − 44 Hydraulic System
Lift Valve Service
Disassembly (Fig. 36)
1. After removing lift valve from vehicle, wash valve in
solvent and dry thoroughly.
2. Carefully mount lift valve in a vise so that mounting
pads are against jaws of vise. Lift valve spool retaining
ring (item 14) should be facing up.
3. Remove two (2) hex cap plugs (item 1) from side of
valve body. Inside valve body, behind each hex cap plug,
there is a spring (item 3), ball (item 4) and cam pin (item
6); remove these parts.
NOTE: Remove check ball seats (item 5) only if they
need replacement; the seats are press fit into the valve
body.
4. Remove retaining ring (item 14) from spool (item 8).
Remove spool retaining ring (item 13), spring retainer
(item 10), spacer (item 12), spring (item 11) and second
spool retaining ring (item 13). Carefully push and twist
spool to remove spool from valve body.
IMPORTANT: When removing O−rings from valve
body, be very careful to not scratch valve bore fin-
ish.
5. Use a hooked scribe or thin screwdriver to remove
O−rings (item 9) from inside bore of valve body. These
O−rings are the seals for the spool.
6. Inspect all components for wear, paying special
attention to the spool. Signs of wear on one side of the
spool may indicate a bent spool. Inspect the spool for
flatness and replace if necessary.
Assembly (Fig. 36)
1. Clean all components thoroughly before assembly.
Use new O−rings when assembling lift valve.
2. Coat all O−rings and spool with clean hydraulic oil be-
fore installation into valve body. Assemble components
in reverse order of disassembly. Install spool into valve
body before inserting cam pins, balls, springs and hex
cap plugs.
1. Hex cap plug (2)
2. O−ring
(2)
3. Spring (2)
4. Check ball (2)
5. Check ball seat (2)
6. Cam pin (2)
7. Valve
body
8. Spool
9. O−ring
10. Spring retainer
11. Spring
12. Spacer
13. Spool retaining ring
14. Retaining ring
Figure 36
1
2
3
4
5
6
7
8
9
10
11
12
13
14
10
9