4
Installing the Lift Actuator
Parts needed for this procedure:
1
Lift actuator
1
Clevis pin (3-1/2 inches)
1
Clevis pin (2-1/4 inches)
2
Hairpin
1
Hex-head bolt (1/2 x 5-1/2 inches)
1
Locknut (1/2 inch)
Procedure
1.
Align the hole in the lower-mount point for the
lift actuator with the holes in the chassis-mount
brackets (
).
2.
Secure the lift actuator to the chassis-mount
brackets with the clevis pin (2-1/4 inches) and
hairpin (
).
g024929
Figure 9
1.
Lift actuator
3.
Clevis pin (2-1/4 inches)
2.
Chassis-mount brackets
4.
Hairpin
3.
Connect the 2-socket electrical connector of the
rear wire harness of the machine to the 2-pin
connector of the lift actuator (
Note:
The 2-socket electrical connector of the
rear wire harness is located adjacent to the
electrical-control cover.
g025011
Figure 10
1.
2-socket electrical
connector (rear wire
harness)
3.
Electrical-control cover
2.
2-pin connector (lift
actuator)
4.
Lift actuator
4.
Connect the negative-battery terminal to the
battery.
5.
Press the up-paddle of the bed-lift switch to
extend the actuator (
).
Note:
If the lift actuator does not extend, press
the other paddle of the switch.
6.
Align the up-paddle to the 12 o’clock position
and insert the bed-lift switch into the opening
in the dash (
).
Note:
The switch should snap and lock into
position.
7
