Toro 07385 Workman HDX-D, Руководство оператора

Страница: 38 / 60

Lubrication
Greasing the Bearings and
Bushings
Service Interval: Every 100 hours (lubricate more frequently
in heavy duty applications).
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium-Base Grease.
The grease fitting locations and quantities are as follows:
•
Ball joints (4), tie rods (2), pivot mounts (2) and steering
cylinder (2) (
Figure 38 )
•
Spring tower (2) ( Figure 39 )
•
Clutch (1), accelerator (1), brake (qty.1) ( Figure 40 )
•
U-joint (18) and 4 wheel drive shaft (3) ( Figure 41 )
Important:
When greasing the drive shaft universal
shaft bearing crosses, pump grease until it comes out
of all 4 cups at each cross.
1. Wipe each grease fitting clean so foreign matter cannot
be forced into the bearing or bushing.
2. Pump grease into each bearing or bushing.
3. Wipe off excess grease.
Figure 38
Figure 39
Figure 40
38