Figure 66
1.
.200 — .350 inch Clearance
3. Maximum high idle speed 3650 rpm. High idle stop
should not be adjusted.
Adjusting Brake Pedal
Service Interval:
Every 200 hours (Front hood can be
removed to ease adjustment.)
1. Remove cotter pin and clevis pin securing master
cylinder yoke to brake pedal pivot (Figure 67).
Figure 67
1.
Master cylinder yoke
2.
Brake pedal pivot
2. Lift up on brake pedal (Figure 68) until it contacts
frame.
3. Loosen jam nuts securing yoke to master cylinder
shaft (Figure 67).
4. Adjust yoke until its holes align with hole in brake
pedal pivot. Secure yoke to pedal pivot with clevis
pin and cotter pin.
5. Tighten jam nuts securing yoke to master cylinder
shaft.
Note:
The brake master cylinder must relieve
pressure when properly adjusted.
Figure 68
1.
Brake pedal
2.
Clutch pedal
Adjusting Clutch Pedal
Service Interval:
Every 200 hours
Note:
The clutch pedal cable can be adjusted at the bell
housing or at the clutch pedal pivot. The front hood can
be removed to ease the access to pedal pivot.
1. Loosen the jam nuts securing the clutch cable to the
bracket on the bell housing (Figure 691).
Figure 69
1.
Clutch cable
3.
Return spring
2.
Jam nuts
4.
Ball joint
Note:
The ball joint may be removed and rotated, if
additional adjustment is required.
2. Disconnect the return spring from the clutch lever.
3. Adjust the jam nuts/or ball joint until the back rear
edge of the clutch pedal is 3.75” + .12” from the top
51
Содержание 07362TC
Страница 57: ...Schematics Hydraulic Schematic Rev A 57...
Страница 58: ...Electrical Schematic Rev A 58...
Страница 59: ......
