2
4. Slide the slotted bracket on the front support between
the fender and vehicle. Loosely attach the front supports
to the floor of the vehicle using the existing hardware
on the vehicle (Fig. 1).
5. Secure the fenders with the bolts removed in step 3.
6. Loosely attach the canopy to the front supports using 4
long screws (5/16 x 2-3/4 in.), 8 flat washers (5/16 in.),
and 4 flange nuts (5/16 in.) (Fig. 2).
Note: The canopy support is already loosely attached to the
canopy (Fig. 2).
6
1
2
3
4
5
5
Figure 2
1.
Canopy
2.
Right-hand front support
3.
Left-hand front support
4.
Screw, 5/16 x 2-3/4 in.,
and washer, 5/16 in.
5.
Flange nut and washer,
5/16 in.
6.
Canopy support
7. If your vehicle has a ROPS, insert the clinch nuts into
the holes in the ROPS (Fig. 3). Lift the canopy and
attach it to the ROPS with 2 screws (3/8 x 1 in.) and 2
flat washers (3/8 in.) (Fig. 3). If your vehicle does not
have a ROPS, lift the canopy assembly and attach it to
the rear support tube with 2 screws (5/16 x 2 in.), 4
washers (5/16 in.), and 2 flange nuts (5/16 in.) (Fig. 4).
1
3
4
2
Figure 3
Vehicle with ROPS
1.
ROPS
2.
Clinch nut
3.
Canopy
4.
Screw, 3/8 x 1 in., and
washer 3/8 in.
1
2
3
4
Figure 4
Vehicle without ROPS
1.
Rear support tube
2.
Canopy
3.
Screw, 5/16 x 2 in., and
washer, 5/16 in.
4.
Flange nut and washer,
5/16 in.
8. Starting at the bottom of the vehicle and working your
way to the top, tighten all of the fasteners.
9. Adjust the front suspension; refer to Adjusting the Front
Suspension in the vehicle Operator’s Manual.
