Toro 07287TC, Руководство оператора

Страница: 16 / 44

3. Remove the adhesive strip from the back of
the battery pad and install it to the front inside
face of the rear frame as shown in Figure 10.
Note:
The pad should be approximately 1/4
inch below the bottom edge of the upper set
of cut-out holes (Figure 10).
Figure 10
1. Battery pad 3. Upper cut-out holes
2. Front inside face
4. Install the batteries as shown in Figure 11.
Note:
Pay attention to the battery polarity
when installing the new batteries (Figure 11).
Incorrect battery cable routing could
damage the vehicle and cables causing
sparks. Sparks can cause the battery
gasses to explode, resulting in personal
injury.
Always ensure the battery polarity when
making connections.
Batteries can give you a powerful
electrical shock.
• Use tools with plastic handles or
wrap the handles of metal tools with
electrical tape.
• Be careful not to contact both a
positive terminal and a negative
terminal at the same time.
Figure 11
5. Install the battery retainers and torque the nuts
to 150 to 200 in-lb (17 to 22 N
⋅
m).
6. Connect the batteries together with the battery
cables included in loose parts, as shown in
Figure 11. Ensure the cable routing does not
allow cables to contact any sharp edges.
Important:
Check all high current
battery connections to ensure they have
been properly secured.
7. Tighten the bolt and secure the other side of
the clip with a new bolt (5/16 x 3/4 inch) and
flange nut (5/16 inch) (Figure 11).
8. Connect the long, red, main positive lead
between the bank of batteries and the vehicle
(Figure 11).
9. Connect the long, black, main negative lead
between the bank of batteries and the vehicle
(Figure 11).
Loose or improperly secured battery
connections could damage the vehicle
and cables causing sparks. Sparks can
cause the battery gasses to explode,
resulting in personal injury.
Always ensure the battery polarity when
making connections.
10. Torque the nuts securing all battery cables to
120 to 180 inch-lb (13.5 to 21 N
⋅
m).
16