Toro 07236, Руководство оператора

Страница: 37 / 52

Replacing the Headlight
1. Disconnect the battery; refer to Disconnecting
the Battery (page 34) .
2. Open the hood; refer to Raising the Hood (page
27) .
3. Disconnect the electrical connector for the
harness from the connector of the lamp
assembly (
Figure 39 ).
g036873
Figure 39
1. Speed clip 4. Headlight
2. Opening in the bumper 5. Lamp assembly
3. Adjustment screw 6. Harness-electrical
connector
4. Remove the speed clips that secure the
headlight to the headlight bracket (
Figure 39 ).
Note:
Retain all parts for installation of the new
headlight.
5. Remove the headlight assembly by moving it
forward through the opening in the front bumper
(
Figure 39 ).
6. Install the new headlight through the opening in
the bumper (
Figure 39 ).
Note:
Ensure the adjustment posts are lined up
with the holes in the mounting bracket behind
the bumper.
7. Secure the headlight assembly with the speed
clips that you removed in step
4 .
8. Connect the electrical connector for the harness
to the connector of the lamp assembly (
Figure
39 ).
9. Adjust the headlights to direct the beams to
the desired position, refer to
Adjusting the
Headlights (page 37) .
Adjusting the Headlights
Use the following procedure to adjust the headlight
beam position whenever a headlight assembly is
replaced or removed.
1. Turn the key switch to the O
N
position, and turn
on the headlights.
2. At the back of the headlight assembly, rotate
adjustment screws (
Figure 39 ) to pivot the
headlight assembly and align the position of the
cast beam.
37