Toro 07236, Руководство оператора

Страница: 32 / 52

Servicing the Engine Oil
Note:
Change the oil more frequently when operating
conditions are extremely dusty or sandy.
Note:
Dispose of the used engine oil and oil filter at a
certified recycling center.
Engine-Oil Specifications
Oil Type: Detergent oil (API service CH-4, CI-4, CJ-4,
or higher)
Crankcase Capacity: 1.4 L (1.5 US qt) when the
filter is changed
Viscosity: See the table below.
g017503
Figure 32
Checking the Engine-Oil Level
Service Interval: Before each use or daily
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Raise the cargo bed.
5. Use a rag to clean around the oil dipstick ( Figure
33 ) so that dirt cannot fall into the dipstick tube
or oil-filler neck and damage the engine.
g016858
Figure 33
1. Fill cap
2. Oil dipstick
6. Remove the dipstick and wipe it clean.
7. Slide the dipstick into the dipstick tube and
ensure that fully seats (
Figure 33 ).
8. Pull the dipstick out and look at the end.
Note:
Add the oil slowly and check the oil level
often during this process. Do not overfill the
engine with oil .
9. Install the oil dipstick and firmly seat it ( Figure
33 ).
10. Lower the cargo bed.
Changing the Engine Oil
Service Interval: After the first 50 hours
Every 150 hours (twice as often in special
operating conditions; refer to
Maintaining the
Machine under Special Operating Conditions
(page 25)
.
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Start the machine and let the engine run for a
few minutes.
4. Shut off the engine and remove the key.
5. Raise the cargo bed and secure it with the prop
rod.
6. Disconnect the negative battery cable; refer to
Disconnecting the Battery (page 34) .
7. Place a drain pan under the drain plug ( Figure
34 ).
32