Toro 07068, Руководство оператора

Страница: 11 / 36

5. Loosen the jam nuts securing the proximity switch to
the frame and lower the switch until it is 2.6 to 4.0 mm
(0.10 to 0.16 inch) from the sensing plate on the hitch
tongue (
Figure 4 ). Tighten the jam nuts to secure the
adjustment.
G01 1587
1
2
3
4
5
2
Figure 4
1. Proximity switch 4. Sensing plate
2. Jam nut 5. Hitch tongue
3. 2.6 to 4.0 mm (0.10 to 0.16
inch)
4
Installing the Hydraulic
Cylinder
Parts needed for this procedure:
1 Rear-actuator tab
4 Bolt (1/2 x 2 inch)
8 Flat washer (.531 x .063)
4 Locknut (1/2 inch)
2 Bolt (3/8 x 1–1/4 inch)
2 Pin assembly
2 Flange nut (3/8 inch)
Procedure
1. Mount the rear actuator tab to the sweeper frame with
4 bolts (1/2 x 2 inch), 8 flat washers (.531 x .063), and
4 locknuts (1/2 inch). Position the components as
shown in
Figure 5 .
Figure 5
1. Rear actuator tab 2. Sweeper frame
2. Secure each end of the hydraulic cylinder to an actuator
tab with a pin assembly, a bolt (3/8 x 1-1/4 inch), and
a flange nut (3/8 inch)
Figure 6 ).
Note:
Make sure that the rod end (working end) of
the cylinder is attached to the front actuator tab.
Figure 6
1. Front actuator tab 3. Hydraulic cylinder
2. Rear actuator tab 4. Pin assembly
11