Toro 07059LT, Руководство оператора

Страница: 52 / 60

g002136
Figure 65
1. Brake-fluid reservoir 2. Minimum line
6. If the fluid level is low, perform the following:
A. Clean the area around the reservoir cap
and remove the cap (
Figure 64 ).
B. Add DOT 3 brake fluid to the reservoir until
the fluid level is above the Minimum line
(
Figure 65 ).
Note:
Do not overfill the reservoir with
brake fluid.
C. Install the reservoir cap ( Figure 64 ).
7. Close the hood of the machine.
Inspecting the Brakes
Service Interval: Every 100 hours
Important:
Brakes are a critical safety component
of the machine. Closely inspect them at the
recommended service interval to ensure optimum
performance and safety.
•
Inspect the brake lining for wear or damage. If the
lining (brake pad) thickness is less than 1.6 mm
(1/16 inch), replace the brake lining.
•
Inspect the backing plate and other components
for signs of excessive wear or deformation.
Replace any deformed components.
•
Check the brake-fluid level; refer to Checking the
Brake-Fluid Level (page 51) .
Replacing the Service and
Parking-Brake Pads
Service Interval: Every 400 hours
Contact your authorized Toro distributor to inspect and
possibly replace the service and parking-brake pads.
Changing the Brake Fluid
Service Interval: Every 1,000 hours
Contact your authorized Toro distributor.
52