Toro 04730, Руководство по установке

Страница: 6 / 8

g016178
Figure 10
1. Plug (replaces the
breather) 3. Sight window
2. Fill with hydraulic fluid to
top off the main hydraulic
tank here.
2. Install a plug in place of the breather ( Figure 10 ).
3. Trim the dipstick to the marked trim line shown
in
Figure 11 . Ensure that the trimmed end is
smooth; deburr the end as needed.
g236710
Figure 11
1. 9.5 cm (3-3/4 inches) 3. Appropriate hydraulic fluid
level
2. Trim the dipstick here.
4. Fill the leak detector tank according to the
characteristics of your leak detector tank, as
follows:
•
If your leak detector tank has a sight window:
Fill the leak detector tank with hydraulic fluid
until the fluid level is at the middle of the
sight window.
•
If your leak detector tank does not have a
sight window:
Fill the leak detector tank with hydraulic fluid
until the fluid level is at the middle of the fill
marks on the dipstick; refer to
Figure 11 .
5. Install the dipstick on the leak detector tank
(
Figure 12 ).
g236731
Figure 12
1. Dipstick 2. Leak detector tank
6. Install the console arm cover using the hex-head
screws that you previously removed.
7. Connect the battery; refer to your machine
Operator’s Manual .
6