Setup
Media and Additional Parts
Description
Qty.
Use
Operator's Manual
1
Parts Catalog (not included)—refer to the
included postcard for information on obtaining
the Parts Catalog
–
Review the material and save it in an appropriate place.
Note:
Determine the left and right sides of the
machine from the normal operating position.
Installing the Roller
The cutting unit is shipped without a front roller.
Obtain a roller from your authorized Toro distributor
and install it on the cutting unit, as follows:
1.
Remove the plow bolt and flange locknut
securing one of the height-of-cut arms to the
cutting unit side plate (
g292580
Figure 3
1.
Height-of-cut arm
4.
Flange locknut
2.
Adjusting screw
5.
Roller-mounting screw
3.
Plow bolt
2.
Loosen the roller-mounting screws in the
height-of-cut arms (
).
3.
Slide the roller shaft into the height-of-cut arm
on the opposite end of the cutting unit (
).
4.
Slide the height-of-cut arm onto the roller shaft
(
).
5.
Loosely secure the roller to the cutting unit with
the height-of-cut arm and fasteners previously
removed (
6.
Center the roller between the height-of-cut arms.
7.
Tighten the roller-mounting screws (
8.
Adjust to the desired height-of-cut and tighten
the height-of-cut arm mounting fasteners.
Adjusting the Cutting Unit
1.
Support the cutting unit; refer to
Cutting Unit (page 11)
.
2.
Adjust the bedknife to the reel.
3.
Adjust the rear roller height.
4.
Adjust the height of cut.
5.
Adjust the cut-off bar.
Refer to
Adjusting the Cutting Unit (page 5)
for complete instructions for performing these
adjustments.
5
Содержание 04651
Страница 16: ...Notes...
Страница 17: ...Notes...