Toro 04510 Greensmaster 3300 TriFlex, Руководство оператора

Страница: 42 / 52

g014596
Figure 43
1. Prop (not provided) 2. Bedbar-adjusting-screw
nut (2)
Installing the Cutting Units
1. Lift up on the footrest and swing it open, allowing
access to the center cutting unit position (
Figure
44 ).
CAUTION
The footrest can pinch fingers if it falls
into the closed position.
Keep your fingers clear of the area where
the footrest seats while it is open.
g014602
Figure 44
1. Footrest—closed 2. Footrest—open
2. Position the cutting unit under the center
suspension arm.
3. With the latches on the suspension-arm bar
pointing up (i.e., open) (
Figure 45 ), push the
suspension arm down so that the bar fits over
the bar across the top of the cutting unit (
Figure
46 ).
g014609
Figure 45
1. Latch—closed position 3. Latch—open position
2. Suspension-arm bar
g014611
Figure 46
1. Suspension-arm bar 2. Cutting-unit bar
4. Close the latches down and around the
cutting-unit bar and lock them in place (
Figure
45 ).
Note:
You can hear a click and feel when the
latches are properly locked in place.
5. Coat the spline shaft of the cutting unit motor
with clean grease (
Figure 47 ).
6. Insert the motor into the left side of the cutting
unit (as viewed from the operator's position) and
pull the motor retaining bar on the cutting unit
toward the motor until you hear a click from both
sides of the motor (
Figure 47 ).
42