Toro 03763, Руководство по установке

Страница: 12 / 24

5. Subtract the desired (.75 inch or 19 mm) spring
length from the current spring length, and divide
this difference by 0.06 inches to determine how
many washers you need to add to achieve the
desired spring length.
11
Installing the Angled Fitting
For Reelmaster 3550 and 3555
Machines—#1 Front, Center
Cutting Location and Kit Model
133-0150 Only
Parts needed for this procedure:
1
Hydraulic fitting—45° (Part No. 340–101; sold
separately)
Procedure
Important:
For Reelmaster 3550 and 3555
machines—#1 front, center cutting location and
kit Model 133-0150 only; order 45° hydraulic fitting
(Part No. 340–101) and follow the procedure
below.
1. Remove the hydraulic hose from the hydraulic
fitting on the motor.
2. Remove the 2 O-rings on the new 45° fitting,
lubricate them with grease, and install them on
the fitting.
3. Remove the existing fitting.
4. Install the new 45° fitting, positioning the fitting
with the angle of the fitting as shown in
Figure
21 . Torque the fitting to 47 to 58 N∙m (35 to 43
ft-lb).
g190850
Figure 21
1. Cutting unit motor 3. Groomer adjuster
2. 45° fitting
5. Connect the hydraulic hose into the new fitting;
torque the hose fitting to 40 to 64 N∙m (37 to 47
ft-lb).
Note:
Ensure that the fitting is positioned so
that the hose does not contact the groomer
adjuster.
12