Figure 40
1.
Quick-up lever (engaged
position)
3.
Height adjuster knob
2.
Groomer height (HOG)
4.
Number of rear roller
spacers (below side plate
pad)
5.
Repeat step
on the opposite end of the groomer.
Then, recheck the setting on the first side of groomer.
Height setting on both ends of the groomer should be
identical. Readjust as required.
Important:
After adjusting the height of the
groomer, adjust the jam nuts on threaded rod,
so the springs are 1-3/8 inch (3.5 cm) long when
the groomer levers are in the disengaged position
(handle pointed towards rear of cutting unit)
(
Note:
1-3/8 inches (3.5 cm) is the distance from
the top of the jam nut to the bottom of the groomer
mounting bracket.
Figure 41
19
