Toro 03698, Руководство оператора

Страница: 17 / 28

g006502
Figure 26
1. Rear spacers 3. Aggressiveness of cut
2. Side-plate mounting flange
Rear Spacers
The number of rear spacers determines the
aggressiveness of cut for the cutting unit. For a given
height of cut, adding spacers, below the side-plate
mounting flange, increases the aggressiveness of the
cutting unit. All cutting units on a given machine must
be set to the same aggressiveness of cut (number
of rear spacers, Part No. 119-0626), otherwise the
after-cut appearance could be negatively affected
(
Figure 26 ).
Groomer
These are the recommended height-of-cut settings
when a groomer kit is installed on the cutting unit.
17