32
Lubricating the Mower
Before servicing or making adjustments to the
machine, stop the engine and remove the key from
the switch. Lower the cutting units to the ground.
Warning
Greasing the Bearing and Bushings
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base Grease.
If machine is operated under normal conditions, lubricate
all bearings and bushings after every 50 hours of operation.
Lubricate bearings and bushings immediately
after every
washing, regardless of the interval listed.
The grease fitting locations and quantities are:
•
Engine Drive shaft (3), (Fig. 35)
•
Cutting unit carrier frame and pivot (2 ea.), (Fig. 36)
•
Rear lift arm pivots (2), Drive shaft clutch (1) (Fig. 37)
•
Rear axle tie rod (2), Steering cylinder ball joints (2),
Axle steering pivots (2) Rear axle pivot (1) (Fig. 38)
•
Traction control linkage at transmission (1), Drive shaft
support bearing (1), Rear axle drive shaft (3) (Fig. 39)
•
Brake pedal (1) (Fig. 40)
•
Lift cylinders (5) (Fig. 41)
•
Front lift arm pivots (3) (Fig. 42)
•
Fan drive pulley (Fig. 43)
Figure 35
Figure 36
Figure 37
Figure 38
Содержание 03550 Reelmaster 5500-D
Страница 33: ...33 Figure 39 Figure 40 Figure 41 Figure 42 Figure 43 ...
Страница 34: ...34 Service Interval Chart Figure 44 ...
Страница 44: ...44 Hydraulic Schematic ...
Страница 48: ...48 Wiring Diagram ...
