Issued:
24.03.11
Approved:
Mod. No.
5062856.A
Sheet
7
of
12
Part No.
111-5100 (A)
32. Connect the other end of the connector lead (item 19) to the main
loom connector located on the electrical mount panel.
33. Repeat this assembly procedure for the lights and connections on
the right hand side of the machine.
34. Plug the flasher relay (item 13) into the vacant relay socket
located on the right side of the electrical mount panel (with the
writing in the forward position).
35. The front main lights attach to the front ROPS hoop using the
front lights mounting bracket (item 21).
36. Fix this bracket to the front ROPS hoop using two M8*25 set
screws (item 41) each side with the washer (item 38) under each
head and a washer (item 39) M8 nyloc nut (item 40) on the back.
37. Fit the lights (item 29) to the holes in the top surface of this
bracket.
38. The light units (items 16 & 17) must now be assembled onto this
bracket. The next steps refer to the left side lights.
39. Take three M5*20 setscrews (item 27) and place an M5 washer
(item 24) on each.
40. Take the front marker light (item 16) and pass the screws through
the three lugs on its base.
41. Put these screws through the three holes in the inner light
mounting position.
42. Place the M5 plain washer (item 24) and an M5 nyloc nut (item
23) on these three screws.
43. Repeat this procedure for the amber front direction indicator
(with heat sink) (item 15).
44. Connect a connector lead (item 20) to each lamp by passing the
end with just the pins, through the hole in the lamp body from
the inside so that the connector is inside the lamp.
45. Connect the connector to the lamp.
46. Now fit the loose connector (item 37) to the pins on the other end
of this connector. Push the connectors into the plug as shown.
Refer to
Fig 5
.
FITTING INSTRUCTIONS
Continued
