Form No. 3412-332 Rev A
Floating 200 mm (8in) Cutting Unit
5-Plex Mower
Model No. 02821
Installation Instructions
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals known to the State of California to
cause cancer, birth defects, or reproductive harm.
Introduction
Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for product
safety and operation training materials, accessory information,
help finding a dealer, or to register your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Toro Distributor or
Toro Customer Service and have the model number of your
product ready.
This product complies with all relevant European directives.
For details, please see the Declaration of Incorporation (DOI)
at the back of this publication.
Contents
Preparing the Machine ............................................. 2
Preparing the Cutting Units ...................................... 2
Installing the Kit ..................................................... 3
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Qty.
Use
Nut (16 mm)
5
Washer (16 mm)
14
Pin (8 mm)
5
Grease fitting
10
Washer (10 mm)
4
Hex nut (10 mm)
4
Pin (25 mm)
5
Split pin
2
Float-casting pivot
5
Bushing (30 x 20 mm)
10
Bushing (25 x 25 mm)
10
Carriage bolt (M10 x 8.8 mm)
4
Roller
2
Right wing-head stop
1
Left wing-head stop
1
Bolt (M16 x 120 mm)
5
Install the kit.
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3412-332* A
