Tornado DS Series of 175 RPM, Руководство по эксплуатации и техническому обслуживанию, Страница: 8 / 16

8
GENERAL PRECAUTIONS
•
You must be trained in the operation of
this machine before use. Please read
this manual carefully and obtain
operation instructions from your safety
director or your authorized Tornado
distributor.
•
Always operate this machine with all of
the cable removed from the handle.
Failure to do so will upset the precision
balance of the machine.
•
Do not use the Floor Machine for
scarifying or sanding.
•
Care should be taken to keep cable
away from rotating brush.
•
Do not attempt to repair warranted
machines. All repairs must be done by a
qualified and authorized repair center.
Non warranted repairs will be billed
back to the owner of the unit.
•
Do not use any replacement parts
except those specified in the parts list.
Unauthorized parts could cause the unit
to malfunction and will void the
warranty.
FAILURE TO COMPLY WITH THE ABOVE WARNING INSTRUCTIONS
WILL VOID THE WARRANTY
EXTENSION CORD
If an extension cord is used, use only a
three wire 12 gauge extension cord that has
three prong grounding type plugs and three
prong receptacles that accept the machines
plug. Your Floor Machine is equipped with a
14-gauge power cord. Replace or repair all
damaged cables.
PREPARING THE MACHINE
Your Standard Floor Machine will require
some assembly . Refer to the Floor
Machine Assembly Instructions section of
this manual.
FLOOR MACHINE ASSEMBLY
INSTRUCTIONS
•
When you remove the machine from its
carton, you will notice two major
components, the handle assembly, and
the base assembly. You will need a
9/16” box end wrench, a 3/4” box end
wrench, and a 3/4” socket with ratchet
driver to assemble the unit.
•
Remove the handle tube pivot lock lever
bolt and the 3/8-16 lock nut from the
handle tube pivot lock bracket. Remove
the 1/2-13 bolt, lock nut, and the 2 nylon
spacers from the base assembly.
•
Place the handle assembly in position
(as shown). Swing handle tube pivot
support arms up. Align holes with those
in the handle tube pivot lock bracket.
Insert pivot lock lever bolt and assemble
3/8-16 locknut - Do not tighten.
•
Insert the two nylon spacers into the
handle tube pivot hole located at the
bottom of the tube. Align tube assembly
pivot holes with the tube pivot/mounting
hole in the base. Insert the 1/2-13 bolt
through mounting holes and tube.
Secure with the 1/2-13 lock nut.
•
Tighten both nuts so that the handle
pivots without any side play. Plug the
motor cord securely into the handle tube
cord.
PAD PLACEMENT/INSTALLATION
INSTRUCTIONS
•
Place pad on floor.
•
Place pad holder on pad, bristle side
down. Make sure pad overlaps pad
holder uniformly.
•
Turn over pad holder assembly by
grasping pad and pad holder together.
•
Mount pad holder assembly on
machine.