6
1. 3-Speed Switch
2. Carrying Handle
3. Power Cord Storage
4. Air Outlet Vent
5. Air Intake Vent
6. Kick Stand
Ensure machine is in a safe operating location. Do not
place machine in a puddle and make sure it is protected
from drips and splashes.
Plug the power cord into a grounded electrical outlet.
Always unwind power cord completely before operating
machine. Inspect power cord for damage before each use.
Replace cord immediately if damaged.
Place the machine in the desired operating position.
A. Horizontal - dry floors and carpets
B. Tilted - dry floor finishes, paint, etc.
C. Vertical - dry wall and ceiling
Set the desired speed by turning switch.
Check for proper operation before leaving the machine
unattended. Do not move or carry the machine when it is
operating.
To shut-off machine, turn the switch to the off (O) position.
The machine is equipped with an automatic reset motor
overload shut-off thermal sensor to protect motor from
overheating. Should the shut-off thermal sensor trip, it will
reset automatically when the motor has cooled sufficiently,
usually after 15-30 minutes.
A.
B.
C.
To keep machine in good working condition, simply perform
the following maintenance procedures.
Unplug cord from outlet when not in use and before
servicing machine.
1. Inspect power cord for damage after each use. Replace
power cord immediately if damaged.
2. Clean machine with a damp cloth.
3. Check for dust accumulation around the air inlet and
outlet vents and clean if necessary. Blocked vents will
cause the motor to overheat, and may lead to premature
failure. Warranty claims for this type of damage will not
be accepted.
Unplug cord from outlet when not in use and before
servicing machine.
If machine fails to operate:
- Check power cord for damage.
- Check plug connection.
- Check building circuit breaker.
- Thermal sensor shut-off - wait 15-30 minutes to cool.
- Contact service center.
MODEL
3-SPEED BLOWER
Width x Height x Depth
15 in x 18.5 in x 18 in
38.1 cm x 47 cm x 45.7 cm
Weight
22.5 lb / 10.2 kg
Voltage / Frequency
120 V / 60 Hz
Motor Rating
.6 HP, 522 W, 4.35 A
Air Flow
3,800 feet per minute
Speeds - Low/Med/High
710 rpm/1105 rpm/1550 rpm
Power Cord Length
18.5 ft / 5.6 m
Sound Pressure Level LpA
69 dBA
Protection Grade
IP20
MACHINE OPERATION
MACHINE MAINTENANCE
STORING AND TRANSPORTING MACHINE
TROUBLE SHOOTING
MACHINE SPECIFICATIONS
Neatly wrap power cord and store
machine in a cool dry area. Do not
expose to rain, store indoors.
Stack machines for storage as
shown.
CAUTION:
Do not stack beyond
four high. Do not stack during
transporting and secure with strap.
1
2
4
5
6
3
https://harrissupplyind.com - To Order Parts Call 608-268-8080