Tornado 98145, Руководство по эксплуатации

Страница: 9 / 11

9
CAUTION
: Unplug the vacuum cleaner before performing any of these steps.
How to Remove the Bottom Plate
1. Place the vacuum cleaner in the low position (see page 7).
Turn the vacuum over.
2. Slide the clips toward each other (Fig. 18).
3. Remove the bottom plate.
How to Replace the Belt
1. Turn the unit over and remove the bottom plate as described in
the above section.
2. Lift the belt cover and turn toward the outside (Fig. 19 & 20).
3. Remove the agitator by pulling it straight out.
4. Remove the belt from the agitator and motor pulley.
5. Loop a new belt over the motor pulley and over the end of the agitator.
6. Stretch the belt over the agitator while inserting it back into the brush
head housing.
7. Turn the belt cover back over the motor pulley. Make sure cover releases
down into the brush head.
8. Replace the bottom plate by hooking the front end of the plate into the
two ribs on the front end of the brush head housing. (Fig. 21)
Press the bottom plate into place by sliding the clips away from each other.
NOTE: To ensure maximum cleaning efficiency, check the belt regularly to
ensure it is in good condition. Replace the belt if it is stretched, cracked or
if excessive slipping is occurring.
Fig. 18
Fig. 19
Fig. 21
Fig. 20
CAUTION
: Unplug the vacuum cleaner before performing any of these steps.
Fig. 22
How to Clean the Brush Head Hose (CK14/1 PRO)
1. Remove the wand from the wand / hose holder as shown on
page 8.
2. Squeeze the tabs on both sides of the quick clean-out port
and pull away from the vacuum (Fig. 22).
3. Check above and below the port opening for obstructions.
4. Remove any obstructions.
5. Replace the quick clean-out port by squeezing both tabs and
pushing it back into the wand / hose holder.