7
2.
Installation of spray cup for door/window
First, install the spray cup with hairbrush on the short spray nozzle, as shown in
Figure 4 and Figure 5. Install the two small hooks of the spray cup for
door/window onto suspension lugs of the spray cup with hairbrush, and then
trigger the big hook of the spray cup for door/window, and push the spray cup for
door/window up and clutch it onto the body of the spray cup with hairbrush.
(IV)
(V)
Refill water during operation
1.
Unplug the power cord and disconnect the power supply.
2.
Press down the steam button to release the pressure until no steam is ejected out.
3.
Slowly unscrew the safety cap but do not remove it. And the residual steam will
be discharged slowly until no steam comes out. Then place the machine in a cool
place to cool it down for about five minutes. Finally, completely remove the
safety cap.
4.
Use the funnel and measuring cup to refill a suitable quantity of cold or hot water
into the tank.
5.
Re-install the safety cap onto the machine body and tighten it in position.
After the machine is used
1.
After the cleaning machine is used, unplug the power cord and disconnect the
power supply.
2.
Press down the steam button to release the pressure until no steam is ejected out.
When no steam is ejected out, raise the steam button then the safety switch will
take effect.
3.
Slowly unscrew the safety cap but do not remove it. And the residual steam will
be discharged slowly until no steam comes out. Then, place the machine in a cool
place to cool it down for about five minutes. Finally, completely remove the
safety cap.
4.
Empty the residual water in the tank and clean the external surface with a piece of
dry cloth.
5.
Lastly, re-install the safety cap onto the machine body and tighten it in position.
Warnings:
Danger of scalding
