Tormach, Inc.
P: 608.849.8381 / F: 209.885.4534
tormach.com
TECHNICAL DOCUMENT
Page 2
©Tormach® 2017. All rights reserved.
Specifications subject to change without notice.
TD10246_Tool_Post_Install_0317A
Installation
1.
Remove Mounting Block from bottom of Tool
Post and discard. Mounting Block is shown in
Figure 1
.
2.
Inspect surfaces of both carriage and Tool
Mount Plate; remove burrs, wipe off grit
and dirt. If necessary, use hand-held stone
to deburr surface. Spray surfaces with rust
preventative such as WD40®.
3. Position Tool Mount Plate on lathe carriage;
using four M8 x 40 mm Socket Head Screws,
attach plate to lathe carriage (see
Figure 2
).
Figure 1
Figure 2
