Bolt Kit Weight: 336g +/-
Hardware Included
QTY Fastener
QTY Fastener
6
5/16” Flat Washer
3
M8-1.25 Hex Nut
9
5/16” Lock Washer
6
M8-1.25 x 40mm Hex Cap Bolt
4
3/8” Flat Washer
1
Nut Plate
4
3/8” Lock Washer
1
Stiffener Bracket
2
3/8”-16 Hex Nut Grade 5
1
18” Trim Lok Strip
4
3/8”-16 x 1” Hex Cap Bolt
Step 1.
Raise rear of vehicle off of ground and place on ramps or suitable jack stands.
Step 2.
Open the rear hatch and remove the light assembly covers on the driver and
passenger sides.
READ THESE INSTRUCTIONS THOROUGHLY AND ACCOUNT FOR
ALL HARDWARE LISTED BEFORE BEGINNING INSTALLATION!
Step 3.
Disconnect the wiring harness and gently pull the light bulbs out of the light
assembly housing. Remove the (3) hex cap nuts and slide the light assembly housing
rearward. Repeat on opposite side. See Figure [1].
Fig. 1
Step 4.
Remove all screws, bolts, and clips shown in Figure [3] to release the bumper
fascia. Use Figure [2] for reference.
Fig. 2
Fig. 3
